Fedders A6K32E7B User Manual page 4

WINDOW INSTALLATION
INSTALLATION
WINDOW INSTALLATON
Installing Cabinet in Window (Flush Mount)
1. Attach cabinet side seals to the existing holes in the cabinet using
the six (6) screws supplied (Fig. 3).
2. Open window and mark the center of window sill. Carefully
place cabinet in window and align center mark on the bottom tie
bar with the center mark on the window sill.
3. Close window until it touches behind top retainer bar. Do not
close window so tightly that sliders cannot move. (Do not release
your grip on the cabinet until the lower window sash is in its final
position.) (Fig. 4)
4. Attach the cabinet to the window sill by driving two (2) 1" long
screws through each cabinet track into the window sill (Fig. 5).
3
B
A
5
7
F
K
J
Installation Other Than Flush Mount
In order to install the unit with more of it projecting into the room, it
will be necessary to relocate the top retaining bar, side seals and
bottom tie bar.
1. Check to make sure the cabinet's outside side louvers will not be
blocked when the unit is moved farther into the room.
2. Remove the top retainer bar, cabinet side seals and bottom tie
bar from the cabinet. Relocate them for the desired projection
into the room.
4
B
6
F
H
E
D
8
5. Loosely attach the sill bracket to the support bracket, using the
carriage bolt and flange nut (Fig. 6).
6. Using 5/8" long machine screw and flange nut, attach the
support bracket to the cabinet track. Use the track hole that
aligns with the sill bracket on the outer edge of the window sill
(Fig. 7).
7. Attach the sill bracket to the window sill using 1" long screws.
8. Tighten the carriage bolt and flange nut. (Fig. 8)
9. Be sure cabinet maintains its outward pitch. This allows air
conditioner to slant slightly downward (1/2 bubble off on a
carpenter's level) on the outside and prevents water in the
bottom pan from entering the room.
C
D
G
J
I
F
G
I
3. Using the top retaining bar and cabinet side seals as templates,
locate and drill five (5) 7/32" mounting holes on the top of the
cabinet and three (3) on each cabinet side.
4. Use sealing material to fill the holes in the cabinet top and sides
that become exposed when the top retaining bar and cabinet
side seals were relocated.
5. Follow all preceding instructions.
4
Cabinet
A
Cabinet Side seal
B
Top retainer bar
C
Center of window sill
D
Cabinet Track
E
1" long screw
F
Sill Bracket
G
Carriage bolt
H
Support bracket
I
J Flange nut
5/8" long machine screw
K
CAUTION
All supporting parts should
be secured to firm wood,
masonry or metal.
Do not block air circulation to
outside louvers of cabinet.