Epson Stylus NX100 Service Manual page 45

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119
Occurrence
timing Detailed phenomenon
CR position
The LD Roller cannot pick up paper
although the LD Roller attempt to rotate
correctly.
• Operation
• –
The Hopper does not operate during the
paper loading sequence although the LD
Roller rotates to load paper from the ASF
Unit.
TROUBLESHOOTING
Table 3-5. Check point for Paper out error according to each phenomenon
Defective
unit/part name
1. Check if any paper dust is adhered to the surface of the
LD Roller.
ASF Unit
1. Check if the Hopper operates correctly in the paper
loading sequence.
Hopper
Compression Spring
Error Indications and Fault Occurrence Causes
Check point
LD Roller
Hopper
Revision C
Remedy
1. Set a cleaning sheet in the ASF Unit up side
down. Then holding the top edge, try to load the
paper from the Printer driver. The micro pearl
on the LD Roller surface is removed. To
remove severe smear, staple a cloth moistened
with alcohol to a post card and clean the roller
in the same manner.
(Use a post card for
Non-adhesive Area
the base sheet)
CL Sheet
Adhesive Area
Staples
This side down
Cloth moistened
with alcohol
*If the problem is not solved, replace the ASF
unit with a new one.
1. Reassemble the Compression Spring between
the Lower Housing and the Hopper.
Confidential
45