Table of Contents
Advertisement
▲WARNING
Turning off wall switch is not sufficent.
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
▲WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
1. Remove the switch housing from the fan by unscrewing
the three screws and unplugging the connector (Figures
1 & 2).
2. Remove the threaded plug, lockwasher, and nut from
the center of this cover by unscrewing it. You may discard
or keep them for future use (Figure 1).
3. Attach the switch housing to the fitter/light kit by feeding
the wires (black & white) through the hole of the switch
housing, place lockwasher over the fitter/light kit leads &
nipple and fasten the fitter/light kit with the nut provided
onto the nipple. Be sure it is tight enough to prevent fitter/
light kit from vibrating loose (Figure 2).
4. Locate two single wires in switch housing. White and
blue wires labeled "FOR LIGHT" (Figure 2).
5. Connect them to the fi tter/light kit wires (Figure 2);
– White wire to white wire
– Blue wire to black wire
6. Carefully reconnect the connector and push all wires
back into switch housing of fan. Then replace cover with
original screws (Figures 2 & 3).
Installing Light Kit Assembly
To avoid
9
Theaded Plug
Figure 1
Connector
Figure 2
Figure 3
Advertisement
Table of Contents
