Table of Contents
Advertisement
How to Wire Your Ceiling Fan - Pull Chain
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket to
the supply grounding conductor (this may be a bare wire
or wire with green colored insulation). Securely connect
wires with wire connectors supplied.
2. Securely connect the white fan motor wire to the white
supply (neutral) wire using wire connector supplied.
Securely connect the black fan motor wire and blue wire
to the black supply wire using wire connector supplied
(Figure 1). After connections have been made, turn leads
upward and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet box
and the black and blue leads on the other side of the outlet
box.
3. After making the wire connections, the wires should
be spread apart, turned upward and pushed carefully up
into the outlet box, with the grounded conductor and the
equipment-grounding conductor on one side of the outlet
box and the ungrounded conductor on the other side of
the outlet box.
1. Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
2. Check the operation of the fan by gently pulling on the
pull chain switch. (Figure 2)
3. If airflow is desired in the opposite direction, turn the
fan off and wait for the blades to stop turning. Then slide
the reverse switch to the opposite position and turn fan
on again. Your fan model is equipped with a 4-position,
3-speed, pull chain switch. The operating sequence is as
follows:
1st Pull = HIGH
2nd Pull = MEDIUM
Operating Instructions - Pull Chain
3rd Pull = LOW
4th Pull = OFF
Black
Fan Wire
Green Wire
(Ground)
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground) from
Hanger Bowl
4. Secure the ceiling canopy to the hanger bracket with
threaded rods, external lockwashers, and knurled knobs
provided (see page 8). Your fan is now wired to be turned
on and off from the fan pull chain speed control.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
Speed Control
Pull Chain
7
Listed
Black
Outlet Box
Household
Supply
White
Blue
Figure 1
Reversing
Switch
Figure 2
Advertisement
Table of Contents
