CP 521
Error number
in byte 0
1X
Clock fault
H
2X
Clock set
H
Default setting
X : May have different values
4.2
Behavior in Operation
You must note the following if you want to modify the configuration during
operation:
•
The CP 521 can only be plugged in or unplugged when the CPU is in STOP
mode
•
The memory submodule can only be plugged in or unplugged when the
power is OFF
•
To guarantee trouble-free printing, make sure the 25-pin subminiature D
female connector is only unplugged when the CPU is in STOP mode and data
transfer between the CP and the printer has been completed.
When the power is switched off, the battery provides backup for the clock data.
GWA 4NEB 812 6030-02b
Table 4-3. Clock Test Messages
Message
Replace module
Set the correct time with the
programmer "FORCE VAR" or
"FORCE" function
Notes on Operation
Remedy
4-3