Setting The Cp 521 Parameters With The Memory Submodule - Siemens SIMATIC S5 CP 521 Manual

ASCII Mode
7.3.2

Setting the CP 521 Parameters with the Memory Submodule

You can store the parameter setting data on a memory submodule in DB 1.
:
Note
The procedure for setting the memory submodule parameters in ASCII mode is
almost identical to the procedure in print mode. The only difference is in setting
the parameters for parameter block 7 in which additional data must be
specified in ASCII mode.
Entering the parameter blocks
Using the programmer (PG), you must first enter in DB 1 all those parameter
blocks which deviate from the default values. Then transfer DB 1 to the memory
submodule.
Further tips for input:
• When entering text, change the data format from KS to C in alternate lines.
• You can enter comments in addition to the parameter blocks.
Schematic for entering parameter blocks
Parameter blocks can be entered in DB 1 according to the following schematic.
Block separator
":" (3A )
H
Figure 7-2. Schematic for Entering Parameter Blocks in DB 1
7-14
Parameter block
number
CP 521
Configuration
data
GWA 4NEB 812 6030-02b