Printing The Message Text - Siemens SIMATIC S5 CP 521 Manual

CP 521
6.6.1 Printing the Message Text (Job 30
After the "Print out message text XY" job the CP 521 transfers message text XY to
the printer. You specify whether the printer is to execute line feed (LF) or carriage
return (CR) after printing message text XY.
Prerequisites
• You must have configured the message text to be printed on the memory
submodule. Assign a number to each message text when configuring it.
• You must have plugged the configured memory submodule into the CP 521.
Operator inputs required
• Specify the message text number in hexadecimal form in byte 1
• Specify the job in byte 0
- Job 30 : Print message text with CR/LF
H
- Job 40 : Print message text without CR/LF
H
Additional inputs
You can store a further three 16-bit variables in bytes 2 to 7 if you have
configured place holders for variables in the message text.
You must enter the data in the form in which you configured it in the message
text in the memory submodule ( 6.4.6).
At printout, the place holders are replaced by actual variable values.
GWA 4NEB 812 6030-02b
Print Mode
and 40 )
H H
6-45