Table of Contents
Advertisement
8
INSTALLATION
1. UNDER CABINET INSTALLATION
a.
Make sure all preparation steps are completed.
b.
Feed the wires coming out of the hood through the bottom of the cabinet.
c.
Lift the unit up flush against the wall and bottom of the cabinet.
d.
Using the screws and washers provided, insert into each of the keyhole
openings and tightly secure the unit against the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary.
Use the conversion collar for 7" ducting.
e.
Connect 6" or 7" ducting to the collar of the hood.
f.
g.
Finish off by sealing the connection point with aluminum tape.
2.
UNDER CABINET INSTALLATION
a.
Make sure all preparation steps are completed.
b.
Be sure you have the WS38CK (conversion kit) to change the top round
outlet to a top rectangular outlet.
Convert 6" top round to 3-1/4" x 10" top rectangular.
c.
Replace the 6" round duct with half round section duct.
d.
Install the "rectangular section" transition plate on next.
e.
f.
Secure both plates with the screws provided.
g.
Conversion is complete after both plates are secured.
h.
Feed the wires coming out of the unit through the bottom of the cabinet.
i.
Lift the unit up flesh against the wall and the bottom of the cabinet.
j.
Using the screws and washers provided, insert into each of the 4
keyhole openings (2 on each side) and tightly secure the unit against
the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary
Connect 3-1/4" x 10" rectangular ducting to the collar of the hood.
k.
l.
Finish off by sealing the connection point with aluminum tape.
INSTALLATION
(Top round outlet)
(Top rectangular outlet)
(Optional)
Advertisement
Table of Contents
