Removing And Replacing The Fan Tray - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

Extreme blackdiamond 6800: installation guide
Hide thumbs Also See for BlackDiamond 6800:
Table of Contents

Advertisement

S
M
ERVICE AND
AINTENANCE
Caution: Do not slam the power supply into the backplane.
7 Secure the power supply by pushing down on the locking handle until it clicks in
place, and then tighten the screws using a #1 Phillips-head screwdriver.
R
EMOVING AND
The BlackDiamond 6800 fan tray is hot-swappable. You do not need to turn off power
to the BlackDiamond 6800 switch to replace the fan tray. Access to the fan tray is from
the rear of the BlackDiamond 6800 chassis.
To remove and replace the fan tray, follow these steps:
1 Unscrew the ten screws securing the fan tray to the chassis, as shown in
Figure 3-2: Removing the fan tray
2 Pull the fan tray straight back out of the chassis approximately ½ inch; this step
disconnects the power, causing the fans to stop.
3 Allow the fan blades to stop spinning before removing the fan tray completely.
3-4
R
EPLACING THE
F
T
AN
RAY
B
D
LACK
IAMOND
Figure
3-2.
BD_fanx
S
H
I
WITCH
ARDWARE
NSTALLATION
G
UIDE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Blackdiamond 6804Blackdiamond 6808

Table of Contents