F32T And F48Ti Modules; F32T And F48Ti Modules - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

F32T
AND
The F32T and F48Ti modules are shown in
52010
Module status LEDs
1 9
17 25
2 10 18 26
3 11 19 27
Port status
4 12 20 28
5 13 21 29
6 14 22 30
LEDs
7 15 23 31
8 16 24 32
=
AMBER ACTIVITY
GREEN = LINK OK
=
FLASHING GREEN DISABLED
1 17
4 20
5 21
8 24
9 25
10/100 Mbps
12 28
ports
13 29
16 32
Figure 1-6: F32T and F48Ti modules
The F32T has 32 autosensing 10BASE-T/100BASE-TX ports. The F48Ti has 48
autosensing 10BASE-T/100BASE-TX ports. All ports use standard RJ-45 connectors. The
default configuration of the F32T and F48Ti modules is as follows:
• All ports are added to the default VLAN as untagged.
• All ports inherit the properties of the default VLAN (protocol type, VLANid, and so
on).
• All ports are in auto-negotiation mode allowing 10 Mbps, 100 Mbps, full-duplex, or
half-duplex operation.
BlackDiamond Switch Hardware Installation Guide
F48T M
I ODULES
52011
STATUS DIAG
10/100 Mbps ports
with status LEDs
Figure 1-6.
EW_F3248
B D 6800 S C
LACK IAMOND WITCH OMPONENTS
1-15