Leds; Reset Button; Console Port - Extreme Networks Alpine 3808 Hardware Manual

Table 23: GBIC types and maximum distances (continued)
Standard
LX
(1310 nm optical window)
ZX
(1550 nm optical window)
ZX Rev 03
(1550 nm optical window)
LX70
(1550 nm optical window)
LX100
(1550 nm optical window)
UTP
*Extreme Networks proprietary. Connections between two Extreme Networks 1000BASE-LX interfaces can use a maximum distance of 10,000
meters.
NOTE
For more information about the supported GBIC types, see "GBIC Specifications" on page 25.

LEDs

Both Summit7i models have the following LEDs:
• Unit status
• Management
• Port status
• Port speed
• Management port
For information about the LEDs and their activity on the Summit7i switch, see "Summit1i, Summit5i,
Summit7i, Summit48i, and Summit48si Switch LEDs" on page 84.

Reset Button

Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.

Console Port

Use the console port (9-pin, "D" type connector) to attach a terminal and access the CLI via a serial
connection. Use the console port for local management.
Extreme Networks Consolidated Hardware Guide
Media Type
50/125 µm multimode fiber
50/125 µm multimode fiber
62.5/125 µm multimode fiber
10/125 µm single-mode fiber
10/125 µm single-mode fiber*
10/125 µm single-mode fiber
10/125 µm single-mode fiber
10/125 µm single-mode fiber
10/125 µm single-mode fiber
Category 5 UTP cable
Summit7i Switch Front View
Mhz•Km Maximum
Rating Distance (Meters)
400 550
500 550
500 550
– 5,000
– 10,000
– 50,000
70,000
– 70,000
100,000
– 80
75