Reset Button; Software Requirements; Summit24E3 Switch Rear View; Power Socket - Extreme Networks Alpine 3808 Hardware Manual

Summit24e3 Switch Rear View

Reset Button

Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.

Software Requirements

The Summit24e3 switch requires that you load ExtremeWare version 6.2e.1 or later and
S24e3BootROM 1.3 or later on your switch.
Summit24e3 Switch Rear View
Figure 39 shows the rear view of the Summit24e3 switch.
Figure 39: Rear view of the Summit24e3 switch

Power socket

Label

SH_24e3rear
Power Socket
The Summit24e3 switch automatically adjusts to the supply voltage. The power supply operates down
to 90 V.
Label
The label on the rear of the Summit24e3 switch displays important information about your switch.
Write down the following information before you install the switch:
• Model number—Shows the model number assigned to this device
• Part number—Shows the part number assigned to this device
• Serial number—Refer to the serial number when you contact Extreme Networks technical support
• MAC address—Shows the unique Ethernet MAC address assigned to this device
NOTE
The label that indicates country and safety certifications for the Summit24e3 switch is located on the
bottom of the switch.
Extreme Networks Consolidated Hardware Guide 93