Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: This unit weighs • Make sure you have enough • We do not approximately 44kgs. space to layout the parts before recommend the Please lift with care. starting.
Page 3
If you have damaged or missing components, call the Components - Panels Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the panels listed below Top/Base (D1015A) (747 x 471mm) Plinth (D1016A) (747 x 85mm) Left Side Right Side Hanging Rail...
Page 4
If you have damaged or missing components, call the Components - Fittings Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Page 5
If you have damaged or missing components, call the Assembly Instructions Customer Helpline: 08456 400800 quoting the reference numbers below Step 1 Prepare the left side Fit 3 hinge plates onto the left side , making sure that the slot is facing towards the finished front edge.
Page 6
Assembly Instructions Step 3 Important: If one of the top/base panels has a plain chipboard surface Prepare the top and this must be used as the base. base Tap 4 wooden dowels into the top and base as shown. Note: Wooden dowels must not stick out from the edge by more than Finished...
Page 7
Assembly Instructions Step 5 Plain chipboard Prepare the plinth surface Tap 2 wooden dowels into the plinth Insert 2 large locking nuts into the plinth Step 6 Fit the plinth Push the plinth onto the right side shown. Use a screwdriver to tighten the large locking fitted to the plinth Note: Support the plinth...
Page 8
Assembly Instructions Step 8 Fit the back The measurement from top corner X to bottom corner X must be equal to the measurement from top corner Y to bottom corner Y Square up the unit by making sure that measurement x to x equals y to y.
Page 9
Assembly Instructions Step 10 Fit the hanging rail Push the hanging rail into the rail holders fitted to the side panels. Step 11 Prepare the doors Push fit 3 hinges into each door Secure each hinge with 2 screws Note: Before securing with the screws, make sure that the hinges are positioned at 90 degrees...
Page 10
Assembly Instructions Step 12 Fit doors and handles Note: The easiest way to attach each door to fit the top hinge first, then align and fit the other hinges. Push the hinge onto the front part of the hinge plate The recess at the bottom of screw B goes into the slot in the hinge plate.
Page 11
Assembly Instructions Step 13 Adjust the doors if needed Before adjusting the doors, use a spirit level to check the base (or top) of the unit is level, front-to-back and side-to-side in the 3 positions shown. Use suitable packing pieces (not supplied) to make the unit level BEFORE making any adjustment to the hinges,...
Page 12
Assembly is complete If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800 and quote the reference numbers on the component pages. Argos Ltd, 489-499 Avebury Boulevard, Central Milton Keynes, MK9 2NW ALR2990...
Page 13
Capella - 5 Drawer Chest Assembly Instructions - 262/0804 Please keep for future reference 266/7788 267/5660 254/9703 227/4061 247/7284 266/5735 274/3877 Dimensions Width - 63cm Depth - 39cm MADE IN Height - 90.4cm BRITAIN Important - Please read these instructions fully before starting assembly...
Page 14
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: This unit weighs • Make sure you have enough • We do not approximately 27kgs. space to layout the parts before recommend the Please lift with care. starting.
Page 15
If you have damaged or missing components, call the Components - Panels Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the panels listed below (D1008A) (596 x 369mm) 4 Rail (D1009A) (596 x 103mm) 2 Right Side Left Side (D1011A)
Page 16
If you have damaged or missing components, call the Components - Fittings Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Page 17
If you have damaged or missing components, call the Assembly Instructions Customer Helpline: 03456 400800 quoting the reference numbers below Step 1 Prepare the drawer fronts Screw 2 metal dowels into the holes shown on the back of each drawer front Note: Tighten the metal dowels up fully against...
Page 18
Assembly Instructions Step 4 Fit the drawer base Slide the drawer base down the grooves in the drawer sides and down into the groove in the drawer front . Step 5 Fit the drawer back Fit the drawer back . between the drawer sides Make sure that the...
Page 19
Assembly Instructions Step 8 Prepare the left side Place 5 runners the left side . Slide back the top of the Profiled runner and use the 1st front edge hole from the front to fit the 1st screw Slide the runner back Profiled the other way and fit the front edge...
Page 20
Assembly Instructions Step 9 Prepare the right side Place 5 runners the right side . Slide back the top of the runner and use the 1st hole from the front to fit Profiled the 1st screw front edge Slide the runner back the other way and fit the 2nd screw into the...
Page 21
Assembly Instructions Step 9 Prepare10the top Tap 4 wooden dowels into the top shown. Note: Wooden dowels must not stick out from the edge by more than 10mm or they may damage other panels. Finished front edge Insert 4 large locking nuts into the top as shown.
Page 22
Assembly Instructions Step 12 Prepare the rails Tap 2 wooden dowels into each of the rails Insert 2 large locking nuts into each of the rails Step 13 Fit the rails Push the rails onto the right side shown. Use a screwdriver to tighten the 3 large locking nuts fitted to...
Page 23
Assembly Instructions Step 14 Fit the left side Push the left side onto the assembly. Use a screwdriver to tighten the 5 large locking nuts fitted to the top and the rails Step 15 The measurement from top corner X to bottom corner X must be equal to the measurement from top corner Y to bottom corner Y Fit the back Square up the unit by...
Page 24
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800 and quote the reference numbers on the component pages. Argos Ltd, 489-499 Avebury Boulevard, Central Milton Keynes, MK9 2NW ALR2993...
Page 25
Important - Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, please visit www.argos-support.co.uk or email: Help@ClickSpares.co.uk (quoting your original order number) Alternatively, call the Spares Helpline on: 0370 112 1928.
Page 26
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: This unit weighs • Make sure you have enough • We do not approximately 13kgs. space to layout the parts before recommend the Please lift with care. starting.
Page 27
Components - Panels If you need help or have damaged or missing parts, please visit www.argos-support.co.uk or email: Help@ClickSpares.co.uk (quoting your original order number) Alternatively, call the Spares Helpline on: 0370 112 1928. For any other queries please contact the Customer Helpline on: 0345 640 2020...
Page 28
Components - Fittings If you need help or have damaged or missing parts, please visit www.argos-support.co.uk or email: Help@ClickSpares.co.uk (quoting your original order number) Alternatively, call the Spares Helpline on: 0370 112 1928. For any other queries please contact the Customer Helpline on: 0345 640 2020 Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.
Page 29
Assembly Instructions Step 1 Prepare the 3 drawer fronts Screw 2 metal dowels into each of the drawer fronts Note: Tighten the metal dowels up fully against the panels. Step 2 Prepare the drawer sides Insert a small locking into the hole shown on the left drawer side and the right...
Page 30
Assembly Instructions Step 4 Fit the drawer base Slide the drawer base down the grooves in the drawer sides and down into the groove in the drawer front Step 5 Fit the drawer back Fit the drawer back between the drawer sides Make sure that the drawer base...
Page 31
Assembly Instructions Step 8 Prepare the left side Place 3 runners the left side . Slide back the top of the runner and use the 1st Profiled hole from the front to fit front edge the 1st screw Slide the runner back the other way and fit the 2nd screw into the...
Page 32
Assembly Instructions Step 9 Prepare the right side Place 3 runners the right side . Slide back the top of the runner and use the 1st Profiled front edge hole from the front to fit the 1st screw Slide the runner back the other way and fit the 2nd screw into the...
Page 33
Assembly Instructions Step 10 Prepare the top Tap 4 wooden dowels into the top shown. Note: Wooden dowels must not stick out from Finished front edge the edge by more than 10mm or they may damage other panels. Insert 4 large locking nuts into the top as shown.
Page 34
Assembly Instructions Step 13 Fit the 2 rails Push the rails onto the right side shown. Use a screwdriver to tighten the 2 large locking nuts fitted to the rails Support this rail until the left side has been fitted in the next step. Step 14 Fit the left side Push the left side...
Page 35
Assembly Instructions Step 16 The measurement from top corner X to bottom corner X must be equal to the measurement from top corner Y to bottom corner Y Fit the back Square up the unit by making sure that measurement x to x equals y to y.
Page 36
Assembly Instructions Step 18 Assembly is complete If you need help or have damaged or missing parts, please visit www.argos-support.co.uk or email: Help@ClickSpares.co.uk (quoting your original order number) Alternatively, call the Spares Helpline on: 0370 112 1928. For any other queries please contact the Customer Helpline on: 0345 640 2020...