Changing The Rinse Aid Dose - Hanseatic HG6085C147635RW Manual

Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover to the rinse aid
compartment (33).
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the cover to the rinse aid compart-
ment again.

Changing the rinse aid dose

We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the appliance with the (1)
button.
2. Press the (2) button for 5 seconds with-
in 60 seconds of switching on.
3. Push the (8) button to switch to setting
mode.
The indicator (19) will flash.
The current value(
d1
nate on the display (6).
Press the (2) button as often as
required until the desired dose is
displayed ( = low,
d1
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatically
revert to the normal display.
The selected dose setting is saved.
Page EN-15
to ) will illumi-
d5
= high).
d5