Changing The Rinse Aid Dose - Hanseatic HGU4582D10J7710EI User Manual

Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover of the rinse aid dis-
penser (23) .
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the rinse aid dispenser
cover again.

Changing the rinse aid dose

We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
(2) (10)
2. Press the P button (5) for 5 seconds
within 60 seconds of switching on.
3. Push the button (2) to switch to setting
mode.
The indicator (10) will flash. The cur-
rent value ( to
d1 d5
the display (8).
4. Press the P button (5) repeatedly until
the desired dose is displayed (
= high).
d5
5. Around 5 seconds after the last button
push, the dishwasher will automatically
revert to the normal display.
The selected dose setting is saved.
Page EN-15
(5)
) will illuminate on
= low,
d1