Hanseatic HG6085C147635RW Manual page 77

Page EN-36 Troubleshooting table
Problem
The selected
programme will not
start or it stops.
The display (20) is
illuminated although
dishwasher salt has
been added.
The water is not
running or it is running
only very slowly.
The water is not
running off or only
very slowly.
The dishwasher is not
watertight.
The dishwasher can
be switched on/off, but
not cannot be
operated.
The dishwasher can-
not be operated.
The door opens by
itself.
Possible cause
The dishwasher's door is not
closed properly.
The water tap is not properly
on.
The inlet hose is defective.
There is a risk of overflowing.
The electrical water stop sys-
tem has been activated.
The dishwasher salt is clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
The buttons are locked.
This is not an error. The door will open by itself at the end of a pro-
gramme (except for pre-rinse because this programme does not
include main wash and drying). This helps ensure optimal drying
results.
Solution
Close the dishwasher door.
Turn the water tap on com-
pletely.
Contact our Service Centre
(see page EN-39).
Stir the dishwasher salt using
the end of a spoon or similar.
Arrange the inlet hose prop-
erly so that it is not kinked
(please see „Connecting the
inlet hose" on page EN-32).
Turn the water tap on
completely.
Clean the filters (see „Check-
ing and cleaning the filters" on
page EN-28).
Lay out the outlet hose in the
proper manner
(see page EN-30).
Have the door seal replaced
(see „Service" on page EN-39).
Have the defective hose
replaced (see „Service" on
page EN-39).
Close the door.
Unlock the buttons
(see „Button lock / child lock"
on page EN-27).