Unloading The Dishwasher; Changing The Programme - Hanseatic HG6085C147635RW Manual

Page EN-26 Dishwasher operation

Unloading the dishwasher

CAUTION!
Risk of scalding!
Once the programme run has come to
an end the door opens automatically
for the hot steam to escape. Therefore
be careful.
Maintain a suffi cient distance from
■
the door and do not hold your head
or upper body directly above the
open door.
Make sure that children do not open
■
the door if the programme run only
fi nished a short time ago.
Allow the dishes to cool before un-
■
loading the dishwasher.
Trip hazard!
An open dishwasher door can quickly
become a trip hazard.
Close the door after every use.
■
Only leave the door slightly open to
■
cool down.
NOTICE
Risk of damage!
Make sure that children and pets do
■
not stand on the open door.
Once the programme run has come to an end
and the dishes have cooled, you can remove
them.
1. When unloading the dishwasher, start
with the lower rack and then unload the
upper rack. This will prevent water drip-
ping onto the lower layer of dishes from
the top layer of dishes.
2. Leave the dishwasher door slightly open
so that the inside of the dishwasher can
also cool off and dry out.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.

Changing the programme

CAUTION!
Risk of scalding!
If you open the dishwasher door,
hot steam will come out.
Maintain a suffi cient distance from
■
the door and do not hold your head
or upper body directly above the
open door.
Keep children and pets away from the
■
appliance when opening the door.
Make sure that children do not open
■
the door during operation.
You can interrupt an active programme at any
point and start a new programme. But do not
forget to add extra dishwasher detergent if
the programme has already been running
for a longer period and the cover of the dish-
washer detergent dispenser is already open.
1. Press the button (10) to interrupt the
programme.
The two dots in the remaining time
display (14) are permanently illuminated.
2. If required, add extra dishwasher deter-
gent.
3. Simultaneously press the P
(3) buttons until only '-
display.
4. Select the new programme and any addi-
tional options as described on the previ-
ous pages.
5. Press the button (10).
The newly selected programme starts.
(2) and
' appears on the
. - -