Table of Contents
Advertisement
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water ONLY. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam Filter
Felt Filter
Pre-Motor (foam and felt):
With the dust cup removed, remove the
Foam and Felt Filters.
CLEAN PRE-MOTOR FILTERS EVERY
3 MONTHS.
CORD MAINTENANCE
To minimize the risk of power cord damage, DO NOT run the vacuum over the power cord. If this
occurs, immediately shut off power to the vacuum and remove the cord from the brushroll or nozzle.
s h a r kc l e a n . c o m
HEPA Filter
Post-Motor (HEPA):
To access the HEPA filter, press the tab, tilt
the Filter Cover, and lift it from the vacuum.
Remove the HEPA filter.
CLEAN HEPA FILTER EVERY YEAR.
1.
DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around sharp
corners.
5.
DO NOT leave the cord near heated
surfaces.
CLEANING THE BRUSHROLL
1. Detach the pod from the floor nozzle.
2. Remove any blockages or buildup from the airways in the
nozzle. With scissors, carefully cut away any fibers, hair,
or string wrapped around the brushroll. Avoid damaging
or cutting the bristles.
REPLACING FILTERS
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF350
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
MAINTENANCE
Replacement
HEPA Filter
XHF350
s h a r kc l e a n . c o m
Advertisement
Table of Contents
