Maintenance - Shark MATRIX PRO UR2360S Owner's Manual

MAINTENANCE

MAINTAINING THE BASE DUST BIN
Depending on the size of the base, empty the base
dust bin every 30 to 60 days or as needed.
To detach the bin, press the Dust Bin Release
button on the back right side of the base, then
slide out the bin.
s h a r kc l e a n . c o m
To empty the bin, hold it over the trash, then press
the release button with the trash can icon on the
side of the bin. The bin lid will open, releasing
dust and debris. Lightly tap the dust bin against
the inside of the trash receptacle to knock off any
remaining debris. Reinstall the bin by sliding it into
the slot in the base until it clicks into place.
MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12
months or as needed.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, then rinse with cold water ONLY, as soap may
damage them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
first, then the foam filter.
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door and
slide the latch down to lift Filter Door off. Remove
the Post-Motor Filter from the base by pulling the
tab down. Tap the filters clean over the trash. Do not
use water or soap to clean filters as this will cause
damage. To reinstall the post-motor filter, insert it
into the base and replace the filter door.
s h a r kc l e a n . c o m