Table of Contents
Advertisement
EXPro Installation Manual
MOUNTING THE FIRE ALARM PANEL
The Premier EXPRO comes with cable entry point on the top edge of the control panel. It is strongly
recommend that the PCB is removed before the entry holes are drilled. With the PCB removed it also
makes it easier while fixing the back box to the wall.
PLANNING CABLE ENTRY
Fig. 2 below shows the location of the fixing holes and cable entry points.
If any knockout is removed, but subsequently not used then it should be covered up.
The 230Vac Mains cable must be fed into the enclosure via one of the cable entries at the top right
corner of the back box. (Refer to "Connecting the mains").
FIXING THE ENCLOSURE TO THE WALL
Figure 2. Plan View inside enclosure without the PCB and side view for surface installation
Check the build & condition of the wall to decide a suitable screw fixing. The mounting holes are
designed for No. 8 rounded or countersunk woodscrews (or similar).
Remove any debris from the enclosure. Take care not to damage FACP during installation.
Secure the enclosure to the wall using the three mounting holes provided.
Approved Document No: GLT-212-7-1
Issue: 1.7 Author: MF/NRPJ Date: 05/07/2021
www.acornfiresecurity.com
www.acornfiresecurity.com
Page 9
Advertisement
Table of Contents
