Advertisement
eAN3810A
Deployment Guide
Checking a Transport Network
This section describes how to check a transport network. The transport network affects the
Automatic OMCH Establishment feature. Therefore, before commissioning an
eAN3810A,O&M engineers must check whether the OMCH networking and the network
equipment meet the configuration requirements of the corresponding scenario.
Check Methods
O&M engineers can check whether the transport network meets the configuration
requirements of the Automatic OMCH Establishment feature by using either of the following
methods:
Method 1: Confirm with the department in charge of the transport network whether the
transport network meets the requirements.
Method 2:
Preparing Dialing Test Tools
Dialing tests are performed by using test terminals to check whether deployed eAN3810A can
provide services properly. Prepare test terminals and ensure that the test subscriber identity
module (SIM) cards have registered with the Core Network.
1.3.4 Initial Configuration Using the LMT
This section describes the procedure for initial configuration of the eAN3810A using the
LMT.
Prerequisites
Context
Table 1-14
Table 1-14 Parameter preparation
Categor
y
eNodeB
IP
Issue 01 (2017-04-30)
Check the network connectivity. If nodes in the transport network can be pinged, ping
the port corresponding to each node to check whether the transmission channel at each
node is ready.
Check whether the network equipment at each node is configured as required to ensure
that an eAN3810A can automatically establish the OMCH.
You have installed the hardware and connected the cables.
You have logged in to the eAN3810A LMT. For detailed operations, see
pico/xmlhelp/en-us/lmt/lmt_11.xml.
lists the data that needs to be planned and collected before the initial configuration.
Related Command
ADD
IPINTERFACE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Parameter
Value Sample
Name
IP Address
193.168.100.59
IP Address
172.253.254.59
1 eAN3810A Deployment Guide
Description
Used for
connection to
the S1 interface.
Used for
48
Advertisement
