Advertisement
eAN3810A
Deployment Guide
3.
4.
5.
?.2.Configuring eAN3810A Data
This section describes how to configure device data, transport data, and radio data for the
eAN3810A by using the CME.
Procedure
1.
2.
Issue 01 (2017-04-30)
b.
Set basic base station information, including the base station name, ID, version. The
CME provides two types of base station templates:
Base Station template
Radio template
Click Next and set basic information and radio template for each RAT.
The eNodeB ID can be set to any valid value. After the configuration takes effect, the
base station name is automatically changed to ESN, and the eNodeB ID is automatically
changed to the value allocated on the U2000.
After the configuration is complete, click Next. The CME starts to create a base station.
Click Finish to exit the wizard.
Click the required tab (Controller/Base Station/Cell) in the left pane of the planned data
area. On the displayed tab page, select an item. The navigation tree of involved
configuration objects is displayed in the lower part of the left pane. See
Figure 1-4 Configuration window
In area 1, select or search the MO to be configured based on the planned data and
double-click the MO. On the displayed page as shown in area 2, set parameters as
required, and click
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to save the parameter configuration.
1 eAN3810A Deployment Guide
Figure
1-4.
10
Advertisement
