Advertisement
eAN3810A
Deployment Guide
Procedure
Step 1 Run the LST MICROSDCARDPORT:; command to verify that the Port Switch parameter
is On.
Step 2 Log in to the U2000 or Web LMT. Run the SET MICROSDCARDPORT command with
the Port Switch parameter set to On.
----End
Preparing Dialing Test Tools
Dialing tests are performed by using test terminals to check whether deployed eAN3810A can
provide services properly. Prepare test terminals and ensure that the test subscriber identity
module (SIM) cards have registered with the Core Network.
1.2.3 Hardware Installation and Power-on Check
This section describes how to perform hardware installation and power-on checks at the site
after eAN3810A hardware is installed. If a MicroSD card is used for local deployment,
engineers at the site need to insert the MicroSD card to the eAN3810A to load software and
the configuration file.
Prerequisites
Context
The port for housing a MicroSD card is enabled by default on the eAN3810A. Insert a
MicroSD card into the powered on eAN3810A and then restart the eAN3810A to read data
from the MicroSD card. Alternatively, insert the MicroSD card into the powered off
eAN3810A and then power on the eAN3810A.
Table 1-3 Precautions for using an SD card
Deployment Mode
Site deployment
Issue 01 (2017-04-30)
The default value of Port Switch parameter is On upon factory delivery.
The SD card has been prepared.
The eAN3810A is working correctly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Precautions
The eAN3810A automatically detects the MicroSD card
and installs the driver for the card after a MicroSD card is
inserted into the eAN3810A. Then, the eAN3810A
automatically reads the files in the fixed directories on the
MicroSD card and checks the file names and formats. The
eAN3810A compares the software version and
configuration data on the MicroSD card with those on the
eAN3810A. If consistent, it does not load the software or
configuration file on the MicroSD card. If inconsistent, it
loads the software and configuration file on the MicroSD
card.
Note the following points about loading:
If the MicroSD card only stores software, the
1 eAN3810A Deployment Guide
20
Advertisement
