Advertisement
eAN3810A
Deployment Guide
Deployment Mode
Procedure
If...
The eAN3810A has been powered on.
The eAN3810A has not been powered on.
Issue 01 (2017-04-30)
U2000-based commissioning
a.
Ensure that the eAN3810A hardware has been installed and has passed the
installation check. For details about how to perform the hardware installation check,
see section "Checking Hardware Installation" in eAN3810A Installation Guide.
b.
Perform the power-on check. For details about how to perform the power-on check,
see section "Power-On Check on the eAN3810A" in eAN3810A Installation Guide.
SD card+U2000-based commissioning
a.
Ensure that the eAN3810A hardware has been installed and has passed the
installation check. For details about how to perform the hardware installation check,
see section "Checking Hardware Installation" in eAN3810A Installation Guide.
b.
Determine whether to restart the eAN3810A after a MicroSD card is inserted based
on the power-on status of the eAN3810A.
c.
Perform the power-on check. For details about how to perform the power-on check,
see section "Power-On Check on the eAN3810A" in eAN3810A Hardware
Installation Guide.
Check the RUN indicator for hardware faults on the MicroSD card. The RUN
indicator blinks orange (on for 0.125s and off for 0.125s), if the eAN3810A fails to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Precautions
eAN3810A loads only the software.
If the MicroSD card only stores configuration files, the
eAN3810A loads only the target configuration file.
The eAN3810A does not load the software or
configuration file on the MicroSD card and its RUN
indicator indicates a loading failure (steady on) in any of
the following conditions:
−
The MicroSD card is not intended for it.
−
The expected directories or files are not present.
The directories or file formats are not correct.
−
−
Data in the MicroSD card is not encrypted or
integrity protected.
Then...
Insert the MicroSD card into the related port
on the eAN3810A. Remove and reinsert the
Ethernet cable for power supply, and then
go to 3.
Insert the MicroSD card into the related port
on the eAN3810A. Connect the eAN3810A
to a PSE over an Ethernet cable. Power on
the eAN3810A, and then go to c.
1 eAN3810A Deployment Guide
21
Advertisement
