e-Flame USA EF-BLT16 Owner's Manual page 7

PROBLEM
The fireplace does not operate.
The power light is ON, but the flame
effect is not visible.
The heater is not operating.
There is excessive noise when the
heater is operating.
The power light is ON, but the ember
bed flame is not flickering.
There is excessing noise when the
flame is ON, but the heater is OFF.
screen diffuser is to be done using only water and a lint-free cloth. Do NOT use any abrasive
cleaners or textiles on the controls or the diffusing screen.
POSSIBLE CAUSE
The fireplace is not plugged in.
A circuit breaker is tripped or a fuse
is blown.
The ON/OFF switch is defective.
There is loose wiring.
The fireplace is not operating
correctly.
Lightbulbs are not functioning.
Loose wiring.
Incorrect operation.
The heater switch is defective.
The heater assembly is defective.
There is loose wiring.
The vents are dirty or clogged.
Dirty or clogged blower.
The heater assembly is defective.
Light bulbs are not functioning.
Loose wirings.
The rotating flame reflector shaft is
rubbing against the housing.
The flame reflector shaft motor is
defective.
7
SOLUTION
Make sure the fireplace is plugged
into a standard 120V outlet. Check
additional appliances on the circuit;
ideally the fireplace should be on a
dedicated 15-amp circuit.
Call Customer Service.
Refer to operating instructions.
Refer to Replacing the Lightbulbs.
Call Customer Service.
Unplug the unit. Clear the vent area
of dust and debris. Wait ten minutes,
plug the unit in again and turn on the
heater.
Call Customer Service.
Refer to Maintenance of Motors in
Care Maintenance.
Call Customer Service.
Refer to Replacing the Light Bulbs.
Call Customer Service.
Open the back of the fireplace and
reposition the flame reflector shaft.
Turn off the unit prior to servicing.
Call Customer Service.