Alphanumeric Tag; Dimmer - Alinco DR-135TMkIII Instruction Manual

6. Parameters Setting Mode

Alphanumeric Tag

The memory channels stored in the memory-mode can be displayed with an alphanumeric tag
instead of the default frequency display. Program the memory channel first.
There are 67 characters available including A-Z, 0-9.
1.
Enter the set mode while the unit is in memory
mode.
2.
Select alphanumeric tag setting by rotating the
main dial or pressing the UP/DOWN keys. The
display shows [A] flashing.
3.
Rotate the main dial to select a character. Press
the V/M key. The character stops flashing and
is entered.
4.
The same flashing character appears next to it,
ready for the next character to be entered. Re-
peat the same sequence, up to seven characters.
5.
To delete all characters during programming
press [CALL] key.
6.
To exit after setting is done, press one of the
following keys: PTT, FUNC, TS / DCS.
After programming, the alphanumeric tag will be displayed on the designated channels, instead of
the frequency, when in memory mode. The memory channel number and other status icons will
also be displayed. If you wish to see the programmed frequency, press FUNC and it will be dis-
played for 5 seconds. To return to the alphanumeric display, wait 5 seconds or press any key.
Pressing any key followed by FUNC returns to normal operation, regardless of the display status.
IMPORTANT: This function cannot be enabled without programming the memories.

Dimmer

The display illumination can be dimmed.
1.
[LAMP-H] is displayed as default.
2.
Rotate the dial to choose the brighter (H) or
darker (L) position.
(T/E models only)
30