Cable Clone - Alinco DR-135TMkIII Instruction Manual

7. Advanced Operations

CABLE CLONE

This feature will copy the programmed data and parameters in the master unit to slave units. It
copies the parameters and memory program settings.
Connection
Make a cable using 3.5 mm stereo-mini plugs as shown below. Make a master unit by setting and
programming it as desired. Turn off both units. Connect the cable between the DATA jacks on both
master and slave. Turn both radios on after the connection is made.
[Setting: Slave side]
1.
Go to receive mode (VFO or Memory). Avoid using 9600bps data reception.
2.
When it receives the clone data, LD*** shows up on the display.
3.
When the transmission is successfully finished, the display will show [PASS].
4.
Turn off the power. Disconnect the cable and repeat the sequence to clone the next
slave unit.
[Setting: Master side]
1.
Press CALL key with FUNC key pressed. CLONE will be displayed and the radio
enters the clone mode.
2.
Press PTT. SD*** will be displayed and it starts sending the data into the slave unit.
3.
[PASS] will appear on the display when the data is successfully transmitted.
4.
The master radio may stay turned on for the next clone. Turn off the unit to exit from the
clone mode.
If the data is not successfully transmitted, turn off both units, make sure the cable connection is
correct and repeat the entire operation from the beginning. If you quit the operation in condition
that the clone is incompleted please reset the slave unit by refering to P.46.
38
3.5 mm stereo-mini plug
Master side
Master Slave stereo plug 3.5plug process
GND DATA
TX/RX
Slave side