MOTO GUZZI CALIFORNIA EV 1997-2000 Workshop Manual page 236

A
B
C
D
E
F
G
H
GEAR BOX HOUSING AND COVER
GETRIEBEGEHAUSE UND DECKEL
VERSNELLINGSBAK EN DEKSEL
I
L
M
N
O
P
22
Bearing removal
From the gearbox:
• To remove bearings, warm up the gearbox at a tem-
perature of approximately 150° ÷ 160° C.
• Remove the primary shaft needle bearing "A" with the
extractor code 14913100, see chapter 5 section B.
• Remove the external ring of the secondary shaft roller
bearing "B" with extractor code 17945060, see chapter
5 section B.
• Unscrew the screws "C" and remove the locking plate
"D".
• Remove the clutch shaft bearing "E" with the extractor
code 17949260, see chapter 5 section B.
From the gearbox cover:
• Always warm up the cover at a temperature of 150° ÷
160° C.
• Remove the primary shaft ball bearing "F" with the
extractor code 14907000, see chapter 5 section B.
• Remove the clutch shaft roller bearing "G" with the
extractor code 14913100, see chapter 5 section B.
• Unscrew the screws "H" and remove the locking plate
"I".
• Remove the secondary shaft bearing "L" with the
extractor code 17949260.
L
I
H
B
D
E
A
G
F
C
G
EARBOX