MOTO GUZZI CALIFORNIA EV 1997-2000 Workshop Manual page 198

A
RH EXHAUST
ROCKER AND LH
INTAKE ROCKER
KIPPHEBEL AUSLASS
RECHTS UND EINLASS
B
LINKS
SLINGER AFVOER
RECHTS EN
AANZUIGING LINKS
C
D
LH EXHAUST
ROCKER AND RH IN-
E
TAKE ROCKER
KIPPHEBEL AUSLASS
F
LINKS UND EINLASS
RECHTS
SLINGER AFVOER
G
LINKS EN
AANZUIGING
RECHTS
H
ROCKER PIN
I
L
BOLZEN DES KIPPHEBELS
M
STIFT SLINGER
N
O
P
32
+0.032
ø15E8
+0.059
ø4
R
OCKER AND PIN CHECK
Check the wear condition and the dimensions of the pins
and of the rockers; if the read measures are not within
the range indicated on the drawings, it is necessary to
replace them.
Reassembly:
Carry out the disassembly procedures remembering to:
• Replace the O rings under the rocker support
underframe with new O rings upon every reassembly;
• Replace the gasket between the head and cylinders
with a new one every reassembly;
• Tighten the nuts and central stud bolt fastening the
head to the cylinder to the torque indicated in the table
in chapter 4, section B, working crosswise.
E
NGINE