General Assembly Instructions - Vacmaster VH105 Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig.4)
5. Your vacuum comes ready for dry vacuum cleaning with the supplied reusable cloth filter installed. (fig.5)
6. For wet vacuum cleaning, install the supplied foam filter. (fig.6) See page 10 for filter installation.
7. Replace the power head back on the container. (fig.7)
8. Aligning the top section with the latches, and snap into place. (fig.8)
9. Insert the hose into the vacuum port. (fig.9)
10. Choose the desired nozzle and insert onto the end of the hose. (fig.10)
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
 Do not mount the rack over 5 feet from the floor.
 Do not screw the rack to drywall only. Secure the screws to a stud.
 Do not hang from or sit on the vacuum when on mounting rack.
 Do not use the vacuum while it is mounted on the wall mounting support.
 Empty the tank before mounting the vacuum on the wall.
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a double polarized plug (one with the blade wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way. Double insulation eliminates the need for the three wire grounded power
cord and grounded power supply system.
6