Dry Vacuuming Operation - Vacmaster VH105 Operator's Manual

DRY VACUUM OPERATION
DRY VACUUMING
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED 'SAFETY
WARNING:
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the filter is completely covering the filter cage against the power head. (fig.2) (Your Wet/Dry
Vac comes with the reusable cloth filter pre-installed, if not, see page 10 for installation instructions.)
3. Place the power head back on the container, and secure it by locking the latches. (fig.3 & 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the larger end of the hose into the vacuum port on the power head. Push the desired nozzle onto
the free end of the hose. (fig.5 & 6)
5. Ensure the switch is in the 'O' OFF position before plugging into the power supply. (fig.7)
6. Plug in the power cord into the outlet. (fig.8)
7. Turn the motor on by flipping the switch to the 'I' ON position and begin vacuuming. (fig.9)
8. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power cord
from the outlet.
O = OFF I = ON
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
7