Door Alignment; Venting System (Chimney And Chimney Connector); General - Valcourt ANTOINETTE FP7CB Installation And Operation Manual

3.9

Door Alignment

To adjust glass door
1. Move the screen door completely to the top.
2. Move down the glass door to the bottom.
3. Unscrew the two bolts (A) which are located on the lower left of the door (See Figure 29).
4. To adjust, move the door to the left or right as needed.
5. Tighten the 2 bolts.
To adjust screen door
1. Lift the screen and the glass door completely to the top.
2. Unscrew one of the two bolts (A) which are located on the lower right of the screen door
(See Figure 29).
3. Slightly unscrew the other bolt to allow the door adjustment.
4. Move down the screen door to the bottom.
5. To adjust, move the door to the left or right as needed.
6. Without changing the performed adjustment, move up about 6" the screen door.
7. Tighten the 2 bolts.
4.0

Venting System (Chimney and Chimney Connector)

4.1

General

The venting system is the engine that drives your wood heating system. Even the best fireplace
will not function safely and efficiently as intended if not connected to a suitable chimney.
The heat in the flue gases that pass from the fireplace to the chimney is not wasted heat. This
heat is what the chimney uses to make the draft that draws in combustion air and keeps the
combustion gases within the fireplace. You can think of heat in the flue gas as the fuel the
chimney uses to make draft.
Figure 29
31