Resistors - Genie Z-45/22 Service Manual

Service Manual - First Edition
8-4

Resistors

How to Test the Resistors
Two resistors are used to maintain proper control
of boom function speeds. A 10 ohm resistor
reduces voltage to all the boom function switches.
A 15 ohm resistor parallels the 10 ohm resistor to
reduce the voltage to the turntable rotate switch.
Turn the key switch to the off
position and remove the key.
1 Disconnect one of the resistor wires from the
resistor or the opposite end terminal.
2 Connect the leads from an ohmmeter to each
end or wiring of the resistor being tested.
3 Compare the ohmmeter reading with the
resistance rating printed on the resistor.
Part No. 29487 Genie Z-45/22
Section 7 - Repair Procedures
GROUND CONTROLS
7 - 37