Genie Z-45/22 Service Manual page 166

Service Manual - First Edition
a
a water temperature switch
b oil pressure switch
How to Remove the Water
Temperature and Oil Pressure
Switches
Perform this procedure with the
engine off.
1 Remove the 3 bolts from the engine pivot plate.
Swing the engine pivot plate away from the
machine to access both switches.
a
a pivot plate bolts
Part No. 29487
2 Disconnect the wiring from the desired switch.
b
3 Remove the switch from the engine block, and
Specifications
Water temperature switch
Torque
Hex size
Temperature switch point
Oil pressure switch
Torque
Hex size
Oil pressure switch point
a
a
Genie Z-45/22
Section 7 - Repair Procedures
KUBOTA V1702-B ENGINE
then install the new switch. Do not over tighten.
Burn hazard. Contact with hot
engine fluids or components may
cause severe burns.
Always use pipe thread sealant
when installing a switch.
8-18 foot-pounds
11-24 Newton meters
13/16 inch
225° F (107° C) ±2%
8-18 foot-pounds
11-24 Newton meters
1-1/16 inch
7.1 psi (0.5 bar)
7 - 29