Keysight M9203A Startup Manual page 22

Step 5: Verify Operation of the M9203A Module
AgMD2Verify checks the version of the Control FPGA firmware. If the version is
not up-to-date, the tool will automatically propose to update the firmware using
the "Firmware Update Utility". Once the Control FPGA firmware has been
updated successfully, please power off your computer and restart it again for the
update to take effect. You may then proceed with the AgMD2Verify utility as
described in this section.
If a Problem is Found
1. Verify that you have made all configuration settings as shown above.
2. Verify that the RF generator is ON and producing the desired signals at the end
of the cable. This can be done with an oscilloscope.
3. Verify that the problem is reproducible.
4. Contact Keysight technical support for assistance. Contact details may be
found at: www.keysight.com/find/assist.
22 Keysight M9203A Startup Guide