Removing The Inlet Cone; Removing Left Handle Housing; Installing Left Handle Housing; Installing The Inlet Cone - Stihl BGA 86 Service Manual

6.5

Removing the Inlet Cone

Remove the blower, @ 6.4.
N
Pull the inlet cone (13) off the blower (12).
N
Remove the outlet cone, @ 8.2.
N
Disassemble the blower, @ 8.4.
N
6.6

Removing Left Handle Housing

Remove the controls, @ 7.
N
Remove blower (12) with inlet cone (13), @ 6.4.
N
Remove the screen (14).
N
Remove the electrical components, @ 9.
N
Locate the locking tabs inside the handle housing (3)
N
and push off the cover (2).
Lift the handle molding (1) slightly at the locking tabs
N
and take it away.
Remove the soundproofing (4).
N
6.7

Installing Left Handle Housing

3
Push the cover (2) into the guides on the handle
N
housing (3) until the locking tabs (arrows) snap into
place.
Push the handle molding (1) against the handle
N
housing (3) until the locking tabs (arrows) snap into
place.
Fit the soundproofing (4) so that its cutouts engage
N
the tabs on the handle housing (3).
Install the electrical components, @ 9.
N
Push the screen (14) into the guide in the handle
N
housing (3) as far as stop.
Install the controls, @ 7.
N
6.8

Installing the Inlet Cone

Assemble the blower, @ 8.7.
N
Install the outlet cone, @ 8.3.
N
10
2
1
13
12
Push the inlet cone (13) onto the blower (12) so that
N
te marks (arrows) are in alignment.
Install the blower tube, @ 6.9.
N
Install the blower, @ 6.10
N
6.9

Installing the Blower Tube

Fit the nozzle (6) on the blower tube (5).
N
19
Push the blower tube (5) over the outlet cone (19) so
N
that the recess (arrow) engages the cable guide.
13
12
Fit blower tube (5, 6) with blower (12) and inlet cone
N
(13). The bead (arrow) engages the seat (arrow) in
the left handle housing (3).
Install right handle housing (11), @ 6.11.
N
6.10

Installing the Blower

Install the outlet cone, @ 8.3.
N
Install the inlet cone, @ 6.8.
N
5
3
5
BGA 86