Table of Contents
Advertisement
7 Assembling the Blower
2
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery no longer light up: The battery (2) is
fully charged and can be removed from the
charger (3).
► If the charger (3) is no longer required. Dis‐
connect the mains plug (6) from the wall outlet
(7).
6.3
State of Charge
1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4
LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
17.1.
Malfunction in blower or battery.
0458-008-0101-A
3
7
6
5
80-100%
60-80%
40-60%
20-40%
0-20%
6.5
LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7
Assembling the Blower
7.1
Mounting, Adjusting and
Removing the Nozzle
The nozzle can be attached to the blower tube in
3 positions, depending on the height of the user.
The positions are marked on the blower tube.
► Switch off the blower and remove the battery.
3
► Depress the retaining latch (1) and hold it
depressed.
► Push nozzle (3) into required position on
blower tube (2).
► Release the retaining latch (1).
Move the nozzle (3) back and forth until the
lever (1) engages.
8
Removing and Fitting the
Battery
8.1
Fitting the Battery
1
2
English
1
2
3
11
Advertisement
Table of Contents
