VWR SAS Super ISO Instruction Manual page 23

Press ENTER to go to the function.
Select the SELECT function by pressing the "UP" or "DOWN" arrows and press ENTER.
Site/Identity
Start delay
Numbers of
cycle
Select the pre-set configuration desired (between 1 and 8) by pressing the "UP" or "DOWN" arrows and press
ENTER to confirm.
Press START to run the sampling cycle.
Modify one of the eight operator programmable configuration memorised.
If you want to modify the pre-set configuration (composed of site, identity, number of runs, number of cycles) you
must use the MODIFY function.
Switch the unit on by touching the screen for at least two seconds.
Press MENU and select CONFIGURATION function by pressing the "UP" or "DOWN" arrows.
Press ENTER to go to this function.
MENU'
CONFIGURATION
CLEAR
CONFIGURATION
SELECT
CLEAR
Record position
number
CONFIGURATION [1]
ABCDEFGH/1234568
01 02 0111 0222
CLEAR
ENTER
ENTER
Total air
volume
Air volume per
ENTER
cycle
23