Transient Protection Terminal Block Grounding - Emerson Rosemount 2051G Reference Manual

Reference Manual
00809-0400-4101, Rev BA
Transmitter case grounding
Always ground the transmitter case in accordance with national and local electrical codes. The most
effective transmitter case grounding method is a direct connection to earth ground with minimal
impedance. Methods for grounding the transmitter case include:
Internal ground connection: the internal ground connection screw is inside the FIELD TERMINALS side

of the electronics housing. This screw is identified by a ground symbol (
screw is standard on all Rosemount 2051G Transmitters. Refer to
External ground connection: The external ground connection is located on the exterior of the

transmitter housing. Refer to
Figure 4-8. Internal Ground Connection
C
D
E
A. Internal ground location
B. External ground location
C. Positive
D. Negative
E. Test
Note
Grounding the transmitter case via threaded conduit connection may not provide sufficient ground
continuity.

Transient protection terminal block grounding

The transmitter can withstand electrical transients of the energy level usually encountered in static
discharges or induced switching transients. However, high-energy transients, such as those induced in
wiring from nearby lightning strikes, can damage the transmitter.
The transient protection terminal block can be ordered as an installed option (Option Code T1) or as a
spare part to retrofit existing Rosemount 2051G Transmitters in the field. See
Specifications, and Drawings" on page 69
4-9 on page 44
Electrical Installations
Figure 4-8 on page
identifies the transient protection terminal block.
43. This connection is only available with option T1.
A
B
for part numbers. The lightning bolt symbol shown in
Electrical Installations
January 2018
). The ground connection
Figure 4-8 on page 43.
"Ordering Information,
Figure
43