Rear Bezel
The rear bezel fastens to the rear of the projector and surrounds the I/O ports. The I/O panel label
adheres to the outside of the rear bezel. The rear IR lens fastens to the inside of the rear bezel.
If you replace the rear bezel, you need a replacement I/O panel label. You cannot remove the label from
the rear bezel. A new rear bezel does not include a rear IR lens or security plate.
1
Remove the two M3x8 Torx screws from the rear bezel.
2
Pull the rear bezel away from the projector.
3
To replace the rear IR lens, press on one of the tabs on the lens to disengage it from the rear
bezel.
SP7205 Service Manual
43