I/O Emi Shield - InFocus ScreenPlay 7205 Service Manual

I/O EMI Shield

The I/O EMI shield fits over the I/O connectors on the rear of the controller ECA. It fastens to the
controller with eight jack screws.
1 Remove the following items:
Outer handle (page 37)
Rear bezel (page 42)
Top case (page 47)
2 Remove the six 4-40 jack screws and the two Phillips screws that fasten the EMI shield to
connectors on the controller ECA.
3 Carefully pull the I/O EMI shield off of the connectors. Take care not to bend the shield or the
fingers as you work the shield off.
Assembly Notes
•
Make sure the fingers on the shield contact the connectors.
•
Torque the jackscrews to 2 in-lbs (.226 Nm).
•
Lightly snug the Phillips screws. Don't over tighten them.
SP7205 Service Manual 32