Lamp Door And Lamp Module - InFocus ScreenPlay 7205 Service Manual

Lamp Door and Lamp Module

The lamp door fits over the lamp cavity in the projector. It includes a tab that closes the interlock switch
when the door is shut.
The lamp module consists of a metal housing and enclosed reflector assembly and arc tube. A blower on
the side of the lamp module provides cooling air to the arc tube and reflector inside of the housing.
CAUTION The lamp module gets very hot during operation. Allow the lamp to cool for 30 minutes before
handling it. The lamp module gets very hot during operation. Allow the lamp to cool for 30 minutes
before handling it.
1 Place the projector upside down on a soft work surface.
2 To remove the lamp door, loosen the two captive screws that secure it to the projector.
3 To remove the lamp, loosen the captive screw that secures it in the projector, swing the bail on
the top of the lamp module up from its storage position, and then pull the module out of the
projector.
SP7205 Service Manual 35