Rear Ir Receiver - InFocus ScreenPlay 7205 Service Manual

Rear IR Receiver

The rear IR receiver fastens to the chassis. It includes the cable that connects to the controller ECA.
NOTE To replace the rear IR lens, see Rear Bezel on page 42 for information.
1 Remove the following items:
Outer handle (page 37)
Rear bezel (page 42)
Top case (page 47)
Fan assembly (page 26)
2 Unplug the rear IR receiver cable from J518 on the controller ECA.
3 Remove the two M3x8 Torx screws that fasten the rear IR receiver to the chassis.
Assembly Notes
•
Route the cable to the inside of the rear IR receiver ECA.
•
Make sure that the rear IR receiver aligns with the hole in the chassis.
•
Torque the two M3x8 Torx screws to 6 in/lbs (.68 Nm).
•
Connect the cable to J518 on the controller ECA.
SP7205 Service Manual 42