Front IR Receiver and cable
The front IR receiver and cable is located behind the front IR lens in the inner handle. It consists of the IR
ECA and a cable that connects to the controller ECA. The receiver works with others at the rear and both
sides of the projector to provide omni-directional reception of commands from the remote control.
1
Remove the following items:
Outer handle (page 37)
Rear bezel (page 42)
Top case (page 47)
2
Unplug the front IR receiver cable it from J500 on the controller ECA.
3
Slide the front IR receiver upward and out of the alignment slots in the inner handle.
Assembly Notes
•
Route the cable to the left of the front IR receiver ECA and through the saddle at the top of the
inner handle.
•
Make sure that the front IR receiver ECA properly engages the alignment slots in the inner
handle.
•
Connect the cable to J500 on the controller ECA.
SP7205 Service Manual
30