Bottom Case - InFocus ScreenPlay 7205 Service Manual

Bottom Case

The bottom case encloses the bottom half of the projector. When you replace a bottom case, you also
need to adhere a new certification label.
1 Remove the following items:
Lamp door and lamp module (page 35)
Outer handle (page 37)
Rear bezel (page 42)
Top case (page 47)
Inner handle and front vent (page 31)
Controller ECA (page 14)
Fan assembly (page 26)
Chassis (page 11)
Optical engine (page 24)
Side IR receivers and lenses (page 42)
Rubber feet (page 45)
Leveling foot (page 37)
2 Remove the serial number label from the certification label. To do this, carefully use a heat gun or
hair drier to soften the adhesive on the back of the label, then peel it off. Do not lose the serial
number. It is not a replaceable part.
SP7205 Service Manual 9