Removing Disk Drive Assembly - AT&T Lucent Technologies MERLIN LEGEND Installation And Upgrade

Upgrading the MERLIN LEGEND MAIL System
This section describes how to replace the disk drive in the MERLIN LEGEND
MAIL module.
!
CAUTION:
Before touching leads, connectors, pins, and other components when
handling the disk drive, use a properly grounded wrist strap to prevent
damage from electrostatic discharge (ESD).
To replace the disk drive:
1. Busy out the slot in which the MERLIN LEGEND MAIL module is installed.
See Appendix B.
2. Remove the MERLIN LEGEND MAIL module. See Appendix C.
3. Place the MERLIN LEGEND MAIL module on its side with the six-sided
cutout (with two metal handles) facing up (Figure 3-2).
4. Grasp the two metal handles and gently wriggle the part attached to the
handles out of its connectors (Figure 3-2). This is the disk drive assembly
(Figure 3-3).
Figure 3-2. Removing Disk Drive Assembly