Table of Contents
Advertisement
32 MPEG-2 Encoder
Instruction Manual
5.14 "Event Log" Screen
The "Event Log" screen (Figure 5.14) is a "read and write" screen where the following parameters can be displayed or
configured. The data in Error Log can be forwarded to a SysLog database – (see
details). The lines are color coded as follows:
Red font = error message
Blue font = information message
Green font = confirmation or feedback message
1
2
3
4
5
Event Log Destination: See
1
Log Destination Port: See
2
Clear Log: Allows to clear the records generated during unit's boot-up process and operation afterward. The records
3
are cleared if the unit loses power.
Lines to Display: Allows the user to select the number of lines to be displayed. The unit supports up to 400 MB of data
4
or approximately 65,000 lines. The range is 1 to 65,535.
Save Number of Displayed Lines: Allows the user to save the error log on the screen. Please note that the error log
5
would be saved only on the screen and not on any database.
Figure 5.14 - "Event Log" Screen
of Section 5.12.1 for details.
17
of Section 5.12.1 for details.
18
20
,
21
, &
22
of Section 5.12.1 for
Advertisement
Table of Contents
