Table of Contents
Advertisement
5.10 "Main > Output" Screen
The "Main > Output" screen (Figure 5.10) is a "read and write" screen to assign the TS to desired IP, QAM, and ASI outputs:
In the section entitled "TS" under an orange header, the following parameters about the TS are displayed:
1
TS Mapping: indicates the program assigned to the TS. The program information includes the PMT PID, Program
number, Short Name, Major-minor channel number. For example, under TS [100 (1) (Test 1) (3-1)] the following
information is displayed:
100 - indicates the Program MAP Table (PMT) of the program.
1 - indicates the Program number as assigned in
Test 1 - indicates the Short Name as assigned in
3-1 - indicates the Major - minor channel number as assigned in
101 V: Composite 1 - indicates that the input video source is Composite and the elementary stream PID is 101.
102 A: Audio In 1 - indicates that the input audio source is Audio In and the elementary stream PID is 102.
2
Bitrates: indicates the incoming transport stream bitrate and the TS Bitrate (refer
In the section entitled "Output" under blue header, the following parameters about the output TS are displayed:
3
IP: Select the IP address for each program (set in 5.8) or "NONE". When "NONE" is selected, there will be no output
stream, however the IP output configuration settings as done in section 5.8 will be retained for future activation.
QAM: select the QAM RF channel number of the QAM output (see
4
5
ASI: select the physical ASI OUT port number to which TS is assigned.
To disable either IP, QAM, or ASI output, selection option "None" in
1
2
Figure 5.10 - "Main > Output" Screen
Remember to click on the SAVE button to apply the new values/configurations.
3
4
7
of Section 5.7.
8
of Section 5.7.
9
and
1
Section 5.9 for details).
MPEG-2 Encoder
Instruction Manual
5
10
of Section 5.7.
2
Section 5.7 for details).
,
, &
respectively.
3
4
5
25
Advertisement
Table of Contents
