Table of Contents
Advertisement
Section 5 - Configuring the Unit
5.1 Accessing the Unit Via the Web Browser
You must complete the steps described in Section 4 before proceeding as follows:
1. Open a web browser on your computer (Internet Explorer 7 or higher is recommended) and enter the following URL
address (http://172.16.70.1). The "Login" Screen (Figure 5.1) will appear.
2. Enter the following case-sensitive factory-default Username and Password, and click on the "Submit" button.
NOTE: When logged in as Admin, the user has read and write permission. Only one Admin can be logged in
at a time. When logged in as Guest, the user has only read permission. Up to four Guests can be logged in
simultaneously.
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
- OR -
Username = Guest (case-sensitive)
Password = pass (case-sensitive)
Monitoring and configuration of the unit is achieved via a series of web pages described in following sections. The following
read-only information is displayed in a blue "page header"on top of each web page:
ESN: unit's Serial number
Headend name: a user-defined field to make identification easier
Temperature: temperature of unit's chipset
Uptime: time elapsed since last time the unit was turned on
Location: a user-defined field to make identification easier
As shown in Figure 5.2, under the blue "page header" the following Primary tabs will appear:
• Primary tab "Main" includes the following sub-tabs:
Status, Program, Video, Audio, TS Map, TS Config, IP, QAM, Output, and Refresh.
• Primary tab "Network" doesn't include any sub-tab.
• Primary tab "Time" doesn't include any sub-tab.
• Primary tab "Event Log" doesn't include any sub-tab.
• Primary tab "Logout" doesn't include any sub-tab.
Each Primary and sub-tab is described in the subsequent Sections.
Figure 5.1 - "Login" Screen
MPEG-2 Encoder
13
Instruction Manual
Advertisement
Table of Contents
