Table of Contents
Advertisement
26 MPEG-2 Encoder
Instruction Manual
5.11 "Main > Refresh" Tab
The "Main > Refresh" tab can be clicked while you are on any of the following sub-tabs screens: "Status", "Program", "Video",
"Audio", "TS Map","TS Config", "IP", "QAM", and "Output". When clicked, it will update all relevant fields/ parameters of
the active screen as that information is retrieved from the encoder in a real time basis.
5.12 "Network" Screen
The "Network" screen (Figure 5.12) is a read and write screen where the following parameters are displayed or configured:
1
10/100 MAC Address: Indicates the MAC Address of the "Remote Control 10/100" Port.
2
1 GIGE MAC Address: Indicates the MAC Address of the "Data Out GIGE" Port.
3
Software Version: Indicates the software version of the unit.
4
FPGA Version(s): Indicates the current hardware version of the unit's FPGA 1&2 chipsets.
5
QAM Version: Indicates the current hardware version.
6
Hardware Version: Indicates the current hardware version of the unit.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Figure 5.12 - "Network" Screen
Advertisement
Table of Contents
